Skip to main content

Greenhouse Motorized Water Diverter and Humidity Controller

In one of the previous posts we learned the making of a greenhouse temperature controller circuit, here we study how the effects may be enhanced through an automatic water valve actuator and humidity controller circuits. The idea was originally requested by Mr. Leandros Komninos

Technical Specifications


Found one on ebay, these are the detail tehy supply:

1 x RS-360SH Pumping motor
Simple gear-type pumping model, usually used for aquarium, DIY model etcs
Diameter: 2.7 cm
Length: 5.2 cm
Out of the water hole diameter: 4 mm
Rated voltage: 7.2V
Suitable for voltage: 3v-12v DC (marked with a red dot that Terminal is positive)

Seems ideal, but what do you think?. Still looking for a valve system, don't know where to begin!?!? i guess miniature butterfly actuators would be overkill for this.

Oh, here's an additional thought for this setup; can there be an additional set of temp/humidity sensors, and another pump setup as a spray. this would keep the humidity inside the greenhouse ideal. This seems like a setup that might be worth you patenting!

The Design


The requested two designs may be understood with the help of the following discussion:

Referring to the first circuit diagram below which is basically wired as a temperature sensor, is enhanced with a relay stage for automatically switching a motorized valve system or actuator which diverts cold water into the greenhouse water supply pipes in an event when the water temperature tends to rise above a predetermined set level.

Temperature Sensor Circuit Diagram




This circuit is quite identical to the one that's explained in one of the previous articles, for a comprehensive study regarding the circuit details, you could refer to the following article:

Greenhouse temperature regulator

The following design is a simple humidity sensor circuit which could be applied for sensing and controlling greenhouse humidity levels.

As may be seen in the diagram, six NOT gates are connected in parallel for obtaining maximum effectiveness from the devices.

The gates are all positioned as potential difference sensors across their input pins.

The 10M resistor initially holds the inputs to a low logic level since it's connected with the ground supply of the circuit.

The inputs are also terminated to the positive through an appropriately etched PCB to form a closely configured copper mesh layout.

As long as the humidity level is not beyond the undesired threshold, the NOT gates inputs continue to be at a low logic state resulting a high at their outputs which keeps the relay and a connected water sprayer activated.

However, the moment the humidity level tends to cross the set high level it tends to develop a low resistance across the copper mesh PCB forcing the inputs of the NOT gates to become higher in potential until it flips and inverts the individual outputs to logic low, which in turn switches OFF the relay and the water sprayer for the time being.

The 10M resistance may be tweaked for setting-up the desired cut off humidity threshold level.

The LED ON indicates the toggling of the relay and vice versa

Humidity Sensor Circuit






Need Help? Please leave a comment, I'll get back soon with a reply!




Comments

  1. Dear sir,
    I hope your fine and you give me better suggesting for my project
    I am really glade to study this side is verry good for Lerner such as me
    I want to used this circuit for egg encobetr humidity control and temperature is it possible?
    My requirements is like that I want to make such project which includes
    LED display for temperature and humidity
    I want to run one heater for humidity when the humidity reached exec set point the heater will off and then blew the set point heater will on
    Same as for temperature I need spread two Pont for controlling humidity and temperature on one card
    Sir also need to display temprature and humidity Lcd
    I hope you understand my requirements and you give me better solution

    ReplyDelete
  2. Imran, for accurate results you can try a Arduino based circuits as explained here:

    https://homemade-circuits.com/?s=temperature+humidity

    ReplyDelete

Post a Comment