How to Make a Telephone Amplifier

The simple telephone ring tone amplifier circuit explained in this article saves the inconvenience of picking the telephone handset while speaking over a call. This circuit also particularly becomes useful when there's a need of the conversation to become audible to a number of people or a group of people.

Introduction


When the conversation needs to become public the amplifier circuit simply needs to be switched ON so that the on going talks becomes amplified and can be heard loud and clear.

The most impressive feature of the proposed circuit design is that it does not require a direct or physical integration with the telephone line rather everything is done quite wirelessly.

The sensing of the telephone signals is done by the pick-up coil which may be placed very close to the telephone or the telephone wire.

The telephone pickup coil is made up of about 2000 to 3000 turns of 36 SWG super enameled copper wire wound over a plastic/paper former having a diameter of 2 inches.

Since this coil becomes the sole sensing agent should be made with lot of care and concentration.

How it Works


When placed near to the telephone wire, the signals from the wire are transferred to the coil through the principle of mutual conduction and the audio pulses which is created by talking over the telephone mic is picked by the coil and sent to the main circuit for amplification.

The amplifier unit basically consists of the IC CA 3020 which forms the heart of the circuit. It just requires a few other passive components for the IC to become fully operational as en efficient audio amplifier.

The sensed input from the coil is not more than 300 mV, but becomes quite sufficient for the IC CA3020 to process the input into an amplified version over the connected loudspeaker.


How to Setup the Circuit


After you finish assembling the circuit as shown in the figure, connect the pick up coil wire across the input of the amplifier and ground via the shown pot. Use shielded wire for this otherwise many unnecessary stray inputs may get into the amplifier. The pot acts as the sensitivity control or the volume control here.

Now switch on the power to the circuit.

Next gently place the pick up coil near the wire of the handset of the landline receiver.

Now as you lift the handset, the dial tone from the telephone should be heard loud and clear over the amplifier loudspeakers.

Make a call over the phone through another phone, all the audio during the calling procedure will be picked by the telephone amplifier circuit and converted into audible signals.

You may either use a battery for operating the circuit or a simple regulated power supply may be used. Alternatively you may use an AC DC adapter also for powering this circuit.

Need Help? Please send your queries through Comments for quick replies!




Comments

Contact me for Customized Circuits

Name

Email *

Message *


 Follow on G+  Follow on Facebook   Follow on Tweeter  Follow on G+  Follow on G+